MAXSEAL is a cement-based mortar with special additives and controlled aggregates. Once cured, it becomes a suitable waterproofing coating for use on concrete, brick, concrete block, masonry substrates.

MSDS  DATA SHEET

MAXSEAL is applied with a fibre type brush, or a shorthaired nylon fibre brush, which makes it easier for the coating to fill all pores and cavities. With a maxbrush apply a thick layer to form a continuous and uniform coating; do not spread as if it were paint, apply only in one direction, the second coat should be spread in the opposite direction. After the work is finished clean the brushes with water and store for further use.

Consumption
MAXSEAL is applied in two layers. The recommended coverage is 1-1,5 kg/m2 per layer with a total coverage of 2-3 kg/m2.

Application requirements

• Do not use onto gypsum plaster surfaces.
• Do not add cements, additives or aggregates to MAXSEAL.
• Do not use MAXSEAL in contact with very soft water. If sulphates are present in water, use MAXSEAL ANTISULFAT.
• In case of doubt related to the water to be in contact with MAXSEAL or further information, consult our Technical Department.